EHV AC Composite Polymer Insulator 330 kV For Electricity
Dimensions and Characteristics of 330KV AC composite polymer
|Figure. No||Model||Rated Voltage||Specified Mechanical Load||Section Length||Minimum Creepage||Full-Wave Impulse Withstand Voltage (Peak)|
Wet Switching Impulse Withstand Voltage
1 Min Wet Power Frequency Withstand Voltage
|Weight (for Reference)|
1, 330KV AC suspension tension insulators are widely used in
overhead transmission lines and substations.
2, Dead end fittings are up to the requirements from the clients,
usually we use ball, socket, tongue, clevis for suspension
insulators with forged steel or cast steel. The dimensions and
coupling size can be exactly according to the specification
requirements from the utilities.
3, The silicon rubber color of the insulators are also up to the
requirements from the clients and all the silicon rubber materials
past 5000 hours aging test silicon content test and hydrophobicity
4, ECR core rods are used in all the insulators, so we can
guarantee a very good mechanical strength and anti-acid pollution
performance for the insulators.
5, All our insulators were type tested and design tested in
accordance with IEC61109, maximum RIV is 100µV when tested at 1MHz
and10% over nominal line ground voltage for indicated system
6, All the 330KV AC suspension or tension insulators are designed
with two corona rings
1, 330KV AC EHV overhead transmission power lines.
2, 330KV AC EHV substations
1, Very good anti-pollution performance, no need to wash the
insulators after the installation in lines.
2, Very convenient installation because of its light weight and one
whole piece compared with glass insulators and ceramic insulators.
3, Excellent hydrophobicity characteristics can help to void
flashover and guarantee the insulators with very good electric